|
VI ER NU OFFICIEL FORHANDLER
I DANMARK AF DISSE TO AMPLIFIERE
EXPERT 2K-FA LINK TIL SPE HER LEVERING EFTERÅR 2010 ORDRER MODTAGES
INTRO PRIS 41900,00 kr NORMAL PRIS 43900,00 kr SPE
EXPERT 1K-FA 1 KW Solid State Fully Automatic Linear Amplifier |
|
23900,00 kr |
|
-
The smallest in the world Built–in Power Supply and Automatic
Antenna Tuner Dimensions: W 28, H 14, D Weight: approx. -
The most technologically advanced in the world Two CPUs are used, one of which is
dedicated to the transceiver interface requirements (CAT). Pi-L output circuit. Over 13000 lines of software for performance that
cannot be found in any other amplifier. - Fully
Automatic Easy connection with all models "ICOM, YAESU,
KENWOOD, TEN-TEC,
FlexRadio ELECRAFT" for
immediate management of the bands, tuner and antennas. Same performance with all makes or homemade rigs. The operator has only to move the “Frequency Tuning
Knob” in the transceiver!!! - Wide
frequency coverage 1.8 MHz to 50 MHz including WARC Bands. - Full solid
state 1 KW pep SSB out.; 900 W pep CW out (typ.) ; 700 W
pep out. (typ.) on 50 MHz. FULL / HALF power selected according to the operator
SSB/CW power requirement, for digital modes and for linear protection
(automatic). No heating time, immediately ready! Virtually limitless life of the amplification
devices (MOSFETs)! - Automatic
Antenna Tuner built-in Capable of matching 3:1 SWR on HF, and 2.5:1 SWR on Capable of programmable switching of 4 antennas (SO239 connectors). Up to two antennas for the
same band. Bands, Antennas, Tuning conditions are changed in 10
msec. Bands, Antennas and Tuning conditions are managed
also in “STBY“ to support the exciter only. - SO2R - Two inputs available SO239 connectors. - High power gain
(16 dB) In “OPERATE“ the required
drive power is automatically set with an ALC connection and in “STANDBY“ the exciter is
then automatically reset to full power - Very clean
and low distortion output Spurious emissions less than -50 dB ( 50 MHz –60 dB
). 3rd order distortion (two tone test) 36 dB typ. - Input 50
ohm always perfectly matched
SWR less than 1.2:1. - Fully
protected Temperature, Over Voltage, Over Current,
SWR, Reflected Power, Max RF Tuner Voltage, Over Drive, Amp. The correct parameters are continuously
monitored. The same protections are realized in two different
ways: · Via hardware circuits (HW) to assure great spee. · Via the software (SW), to assure great accuracy. Thanks to the SW, transmit relay changeover
is carried out with zero current at the contacts. - Full
break-in operation (QSK) - - Very quiet
operation Seven quiet three-speed cooling fans: · 150 CFM maximum total air flow. Temperature thresholds for speed change: · 65 °C ( · 60 °C (140 *F). and Noise level: · 39 dBa at maximum blower speed. - Continuos
use "FULL" mode: SSB unlimited, key
down 2 minutes. "HALF" mode: SSB unlimited, key
down 5 minutes. -
Regulated power supply, input 230 / 215 / 200 /
115 / 100
Vac With all input voltages the out power doesn't
change. A well designed
grain-oriented, tape-wound toroidal transformer reduces magnetic fields around
the amplifier. -
The linear can be switched ON / OFF also switching ON / OFF the exciter - With a
large LCD display is possible to have a great deal of information W pep out, V pa, I pa, W pep reflected,
Power gain, Temperature (°C, °F), SWR,
Input setting, CAT setting, Band and other indications including an
alarms log. -
Easy to operate Powerful SW gives you a user-friendly
unity. - RS 232 port
for a PC control A SW is supplied to remote the linear frontal panel. With a proper protocol it is possible to
use this port not only as a remote control but also as a CAT
port (useful to link the linear with any customer application). - Easy
transportation A sturdy carry-bag is supplied for “QSY, FIELD DAY, DX’
PEDITIONS etc.“. - Certifications
: |
|
Specifications are
subject to change without notice. |
|
|
